Metal Prep on Right Elevator Parts

I have been working on the shop these past few days, cleaning, organizing and setting up a new tool chest so I haven’t spent much time on the plane.  But, I have my workshop much more organized and easier to work in now. I am planning a primer session this week, so I wanted to finish up the last few parts from the right elevator skeleton.

I only had a few parts to get ready for priming, so I used less than an hours work on prepping the parts. I finished all the edges on the skeleton pieces on the bench grinder, and deburred the machined holes. I still have some drilling to do so I won’t deburr those holes till after they are primed. I aspire leaving the dimpling until after priming because the parts are much easier to scuff and clean. I also finished off the edges for the skins, so they ate ready for priming.

At this point I am ready to prime the rudder and the right elevator. I’ll save the left elevator until the next session. I’d like to finish up the rudder and move on to do the elevators together.

Hours Worked: .75

 

Tagged . Bookmark the permalink.

Leave a Reply