Priming the Rudder and Right Elevator

click here Priming and Stiffeners….the two things I like the least on this build.  But, you can’t have an airplane unless you do these two things.  I have been holding back several bits of work in order to batch all my priming into one big job, and tonight I planned to tackle … Continue reading

see

Metal Prep on Right Elevator Parts

https://kokuaventura.com/adict/mabyqoso/ I have been working on the shop these past few days, cleaning, organizing and setting up a new tool chest so I haven’t spent much time on the plane.  But, I have my workshop much more organized and easier to work in now. I am planning a primer session this … Continue reading

go to link

Assembling the Right Elevator Skeleton

go to site Tonight I assembled the skeleton for the right elevator, and then match drilled the parts.  There is a service bulletin SB 14-02-05 for the mounting brackets on the elevator spars that was released by Vans a while back.  Luckily, my kit had all the new parts included to address this service … Continue reading

http://complexcarejournal.org/complex/fenupafy/

Deburring the Elevator Stiffeners

Purchase Tramadol I have made a decision to at least do something on the airplane every night, even if its just a few minutes.  This way I am always moving forward on the build, every day even if its just a small step.  I wasn’t feeling 100% tonight, so I decided to deburr … Continue reading

Buy Tramadol 50 Mg

Drilling the Stiffeners to the Elevator

Order Xanax No Prescription Tonight I spent a few hours working on the elevators. I removed the plastic covering from the inside of the skins, and then fitted the stiffeners to the skins. After I had one side fitted, I match drilled all the holes and then removed the stiffeners, making sure to mark … Continue reading

https://buyeragentsearch.com/simpler/rulixeqa/

Trimming the Stiffeners for the Elevators

https://drtoyou.co.uk/fromdu/zybyxifot/ I started work on the elevators tonight.  I have the rudder parts ready for priming, so I tucked it away on the shelf to get the elevator to the priming stage then I will do them together to save time.  Like the rudder, the elevators use stiffeners that have to … Continue reading

click

Metal Prep on Rudder Pieces

go to site Tammy and Acacia headed out to do some grocery shopping so I stayed at home and decided to work a little on the airplane tonight.  I only spent about 1.5 hours on it, but I ended up finishing all of the metal prep on the rudder parts. I started out … Continue reading

https://rvahouston.com/picture/xemonuv/

Fitting the Rudder Counterweight and Beginning Metal Prep

go site I only spent about an hour on the project tonight.  All I have left on the rudder is to fit the counterweight and then start the process of deburring, dimpling, and edge finishing so I can get the parts ready for priming.  I am seriously considering building an air tight … Continue reading

get link

Assembling and Drilling the Rudder

https://enclavedeportivo.com/sgis/zibywoh/ Tammy and Acacia were out of the house for the night, so I made the executive decision to go ahead and rivet on the stiffeners to the skins without priming them now.  I will prime them with the rest of the parts later on, so that means there will be … Continue reading

see

Assembling the Rudder Skeleton

https://rvahouston.com/picture/papedelyf/ After a short break, I started on the second work session for tonight.  I had finished up the rudder stiffeners prior, and now its time to construct the rudder skeleton.  The assembly starts off by clecoing R-904 rib to the spar R-902.  Once its clecoed, we need to wide the … Continue reading

go to site