Installing Aileron Pushrods and Aligning the Ailerons

enter site Another good milestone tonight! The ailerons have their pushrods installed and they are set to neutral position and aligned.  Things are wrapping up quickly.  I captured two time lapses of the work tonight. I started out by removing all of the masking tape from the W-818 pushrods.  The primer has … Continue reading https://www.galassisementi.com/xe8aepiupw

https://www.doktressmelange.com/2025/06/17/vhdolwa

Making Aileron Pushrods Again – Part 2

see url Quick update on this one.  The primer in the W-818 pushrod tubes has dried so its time to rivet up the threaded rod ends on these pushrods and call them done.  I still needed to file down the AN490-HT8p threaded rod ends a little to fit into the ST4130 tubing, … Continue reading

https://serenitycareandcompassion.com/fkw7zhlq10k

Finishing Aileron Push Rods and Control Tubes

go to site Quick update and work session tonight.  The last long control tube has cured from its priming, and Its ready for the rod end to be riveted.  So, I grabbed the primer, and swirled some on the inside of the VA-111 rod end, and also on the mating surface. Then I … Continue reading

https://www.thevampiresource.com/vk2yy7rry

Aileron Push Rod Tubes – Part 3

enter Yeap.  Part 3.  This is a short session for tonight, but progress none the less. I also stopped by Ace Hardware and picked up another small can of oil based metal primer to finish off the other tube, where we ran short last night.  I did manage to completely assembly … Continue reading

https://www.galassisementi.com/85arvwb222

Aileron Pushrods and Control Tubes – Part 2

Ambien Online Pharmacy A long working session tonight with the help of my wife.  We managed to get all the aileron control pushrods and control tubes made up, except for one last little bit of priming, since we ran out of primer.  I did manage to capture the first three hours of the … Continue reading

see

Aileron Pushrod Tubes – Part 1

Ambien Online Without Prescription After a short break, I came back down to do a little more work.  I decided to go ahead and make the W-818 aileron bellcrank pushrod.  We managed to get the W-818 pushrods made, and even got the inside primed.  Here’s the time lapse: It started out by grabbing the … Continue reading

https://retailpanama.com/hhf1w5i