Ordered the Wings!

https://serenitycareandcompassion.com/7uatwesj0 I have submitted my order to Vans for the wings!  I have been working with a few folks over the phone discussing a few options, substitutions and additions to my wing kit, and finally got to the point of getting an order completed.  I am still a bit surprised at … Continue reading follow link

follow link

Fitting The Elevators to the Horizontal Stabilizer

source The empennage kit is wrapping up, and almost complete at this point.  All the major assembly is done, and now its just fitting the parts together and lining up the hinges to drill the elevator horns.  The first thing to do is make sure the eye bolts on the elevators … Continue reading

https://www.starc.org/uncategorized/crvu4i2o8o

Finishing the Rudder

https://www.starc.org/uncategorized/man2tua8ie While Tammy and Acacia were taking a nap, I decided to sneak off to the shop and get some work done on the airplane.  Since the trailing edge of the rudder was completed a few days ago, its time to finish it up, and that means bending the leading edge … Continue reading

source site

Riveting the Rudder Trailing Edge

https://www.doktressmelange.com/2025/06/17/qtfuezyiw7r Tonight. I decided to take on the most difficult part of the empennage:  The Rudder Trailing Edge!  This one simple little piece of kit causes the most headache and heartache out of the entire tail section, and for good reason.  If you can’t get a good straight trailing edge on … Continue reading

click here

Mounting the Trim Tab Servo

https://elien.ca/3v7805whm7u Since my rudder trailing edge is still curing, I decided to work on the last remaining task left on the empennage: Mounting the trim tab servo.  I started out the work tonight by wiring up the servo, its indicator and switch to my 12V bench power supply to test its … Continue reading

https://www.doktressmelange.com/2025/06/17/m2hra0m43jh

Bending the Left Elevator Leading Edge

https://jahuss.com/3bu5tbe After getting the right elevator bent,  it was time to move on the left.  This process is pretty much identical to the right elevator, so I will leave out all the details.  I did it exactly this one the same way as I did the right.  First up is to break … Continue reading

https://www.galassisementi.com/0jl7suhfg9e

Bending Right Elevator Leading Edge

https://www.thevampiresource.com/vmoscw41reb With the right elevator all closed up, one of the last remaining steps is to bend the leading edge.  This is a bit tricky to do, and I am using the tried and true method of using a wood dowel rod and some strong Gorilla Tape to get the bend … Continue reading

source

Closing up the Elevators

click here Tonight I was able to close up and rivet both the left and the right elevators. They had been setting and letting the proseal cure, and now it was time to close them up for good.  I started out with the easiest one first, the right elevator.  This one is … Continue reading

get link

ProSeal Party!

get link Today was actually a pretty fun day.  I decided to wait on prosealing the rudder and elevators until I could do it all at once, and save on the cost of mixing up two different tubes for two different sessions.  I also took advantage of having some helpful friends to … Continue reading

https://elien.ca/o6qqp33q0n

Closing up the Trim Tab

Online Xanax Without Prescription I am coming down to the finish line on this empennage kit.  Tonight I finished up with the elevator trim tab, and it is ready to be permanently attached.  I had gotten it nearly completed the last time I worked on it, but I needed to get the elevator riveted … Continue reading

Ambien Mexican Pharmacy