https://brooklyntothecatskills.com/2020/10/20/homemade-coffee-cake/ Tonight I was able to accomplish a part of the fuel tanks that I’ve been worried about. The left tank fuel sender. My left tank is my “acro” tank, and as such has a flop tube installed in the inner most bay, and that forces us to move the float … Continue reading
https://www.autenticmed.com.br/testimonials/
get link Time to work with the black sticky goop again. This time I decided to do a little more prep work, and forgo pitting sealant on the rivets, instead slather it onto the stiffeners first. First things, first: I need to scuff the mating areas, and clean them very well with … Continue reading
https://thermocomfort.ca/windsor/
Order Ambien Without A Prescription Local weather was pretty crappy, so I didn’t go flying in the Cardinal today, and didn’t have anything else on the docket to finish, so I decided to spend some time working on the RV-7. Picking up where I left off, I needed to get the left tank skin dimpled … Continue reading
Get Clonazepam Online
go to link After finishing up a previous build session on the fuel tanks, I decided to change gears a bit, since I got some new tools/toys! I FINALLY bought a proper set of crimpers ands strippers from SteinAir! I was needing these to finish up some wiring on the stall warner. So, … Continue reading
go to site
https://gardenswhisper.com/meet-the-team/ FINALLY got some time to get a little work done on the RV-7 again. Lots of projects going on and been focusing on family time over building. It was good to get back and do some work with my hands though. Not much to report. I was able to get … Continue reading
Buy Xanax Online
https://louldentalstudio.com/sustainable-dentistry/ Quick build log tonight. I finished up deburring the holes in all of the tank ribs. I only had a few minutes to spend, but I managed to get these parts done. Thats pretty much it for tonights work. Hours Worked: .5
https://www.autenticmed.com.br/depoimentos/
Buy Xanax Usa No Proseal work tonight, but its close. I need to get the left tank up to the same point as the right, which means breaking it down, deburring, finishing the edges, and then dimpling. First I need to trim my vent tube, and flare it for its fitting. I measured … Continue reading
Purchase Klonopin Online
Get Ambien Online Another proseal session tonight, but this was a pretty short one. This stuff is still messy, and I still have a hard time dealing with it, because I am not good with messy stuff! I wanted to get the tank drain, and the fuel filler sealed and ready to go, … Continue reading
https://heural.com/en/about-us/Online Pharmacy Xanax Its time. Time to start working with this sticky, smelly, nasty sealant again. I have not really been looking forward to this, but it has to be done. My right tank has been scuffed and semi-cleaned in the last couple of build sessions, so I wanted to give it another … Continue reading
click here I changed it up a bit tonight. I realized I could go ahead and knock out the W-423 splice plate since it needed a little more work per wing. These are the small strips of aluminum that are used as reinforcement plates between where the leading edge and the fuel … Continue reading