Attaching the Right Fuel Tank

https://www.galassisementi.com/x75mbhc I decided to get the right fuel tank attached to the right main spar tonight.  I did a little cleanup work on the fuel tank where the sealant squished out and was causing some interference with the splice plate and not letting it fit snug.  I used a phenolic scraper … Continue reading follow site

https://estherbarniol.com/jbqhy2emm

Riveting the Right Leading Edge and Attaching to Skeleton

enter site ALOT accomplished in this session.  I managed to get the right leading edge fully riveted, AND even got it attached to the right wing skeleton with some help from Tammy. This wing is ready for the fuel tank to be attached, and then on to the top skins.  I managed … Continue reading

https://estherbarniol.com/ddfpykye

Countersinking the Right Wing Skeleton

Ativan 1Mg Online Order Another quick build session. I managed to get the entire right wing skeleton machine countersunk. Pretty simple work, I did have to match drill a few holes I missed somehow, but no biggie. I also sprayed some rattle can primer on the newly countersunk holes. Hours worked: 1.5

https://retailpanama.com/wdjmfvv2

Dimpling Right Wing Skeleton

follow Quick Entry tonight. I’m getting the right wing up to the point where the left-wing is so that I can rivet the skin zone at about the same time. Here’s a time lapse video. I managed to get the right wing skeleton fully dimpled and even managed to remove a … Continue reading

go site

Right Wing Leading Edge Work

Buy Ambien Zolpidem Time to admit a mistake I realized early today:  I forgot to connect the fuel sender wire on the left tank (rear baffle) before I bolted it down! Not a big deal, as I only used a few screws to hold it, and I can easily unscrew and unbolt it … Continue reading

https://www.galassisementi.com/uj5h1cm

Bolting the Left Fuel Tank

https://marchtozion.com/esgwaf1z7 I wasn’t quite sure what category to put this work under at first, but I soon realized I spent ALOT of time on the fuel tank portion, so I’ll put it under there.  I needed to get the scarf joint done on the two wing skins where they overlap, but … Continue reading

https://elien.ca/qlivfkob

Riveting the Leading Edge to the Left Main Spar

Buy Valium Roche 10Mg Wing is taking final shape! I was able to get the left wing leading edge completely riveted on to the main spar tonight, and its looking like a wing!  I also captured two time lapse videos, one closer view, and another overheard.  Here’s those videos: And here is the overhead … Continue reading

source site

Riveting the Left Wing Leading Edge

https://jahuss.com/x7q0zzqclj Man! Got a lot knocked out today! The left wing leading edge is completely riveted, and ready to be attached to the wing skeleton, including the stall warner.  I got a text from Tammy mid-build s her BMW overheated, and was low on coolant, so I had to pause and … Continue reading

go to site

Priming the Leading Edge Parts

https://serenitycareandcompassion.com/4m28ae8c Time to prime!  I was able to completely prime all of the leading edge parts for both wings in this session, including the access cover and plate for the stall horn.  I also realize my AKZO is past its shelf life, but it seemed to spray just fine and I … Continue reading

Ativan 1Mg Buy Online

Countersinking Left Wing Skeleton

enter I forgone priming tonight, I’ll do that this weekend.  But, I did get some good progress on the left wing skeleton.  I completed all of the machine countersinking on the main spar, so its ready for skins!  Here’s the timelapse: I chucked up my microstop countersink cage in my Sioux … Continue reading

https://marchtozion.com/3hr38zta49u